EM-F Flat Modular Belt Conveyor


The EM-F with plastic modular chain has a completely closed stainless steel frame. The chain can have a closed surface like shown in the picture on the left or it can be an open chain. Thus the EM-F is a good solution for the transport of still unpacked or already packed food stuff. But it also meets the high hygienical standards of pharmaceutical and chemical industry.

The conveyor comes in a very slim design. The frame is only 14 mm wider than the chain. Also at the defecting roller the brackets add only a few millimeters more so that the total width there is 40 mm more than the belt width itself. The whole height including the chain is only 95 mm.

There are 4 different belt widths between 152 and 607 mm to choose from and the EM-F can be made in any lenght between 500 and 6000 mm. For its production we need between 4 and 6 days.

The modular plastic chain is very easy to clean and especially hard wearing. Any broken or worn links can be exchanged, which allows rapid maintenance. With the wide range of GEPPERT accessories available, the AM-F can easily be adapted to almost any specific need.

For any length of 1500 mm or less and a width of up to 304 mm the EM-F can be equipped with our single columm upright like shown with the GES-25. Longer or lager versions should use the appropriate numer of two-legged aluminium supports as shown above.

Both support systems are infinitely adjustable in height and pivotable as well as self locking in their vertical position.

Technical Specifications and Accessories

Belt widths:
153, 305, 457 and 610 mm. Other widths are available upon request.

Distance between axes / length:
500 to 6.000 mm. All intermediate lengths are possible.

Drive with constant belt speed:
v = approx. 5,6 / 10,4 / 15,6 / 20,8 / 31,2 or 44,6 m/min.
Other belt speeds are possible on request. Connection for 220/240 – 380/415 V, 50 Hz. Protection type IP 65. This drive can be supplied together with a motor protection switch incorporating an emergency off. It has a 2 metre supply cable and CEE plug and is of protection type IP 65.

Drive with infinitely adjustable belt speed:
v = ca. 2,2-7,8 / 4,2-14,6 / 6,2-21,8 / 8,3-29,1 / 12,5-43,7 or 17,8-62,4 m/min.
Other belt speeds are possible on request. The drive is supplied together with a frequency regulator that is ready to be plugged to 240V 50 Hz and has a protection type of IP 65. The frequency controller incorporates a digital motor protection switch.

Geared motor positions:
Pulling at the side of the belt, on the left or right.

Total belt load:
Standard is of 50 kg. Higher loads are possible on request.

EM-F Operating Manual